IQMIX25/26/40/41
RollCall Control Panel
Issue 1 Rev 4
Page 33
© 2017 SAM
5.9 Ethernet Pages 1 and 2
The
Ethernet
pages show details and status for each network interface. The IQMIX defaults
to use of DHCP, but this can be overridden and a static IP address defined if required.
5.9.1 The Ethernet Pane
The
Ethernet
pane displays details of the currently selected network interface, and allows a
static IP address to be defined. Enter information as required, then click
S
to save. New
settings are applied when
Restart
is clicked.
Where am I? Checkbox
When enabled, the
Where Am I
function causes the SFP/QSFP LEDs for the relevant
Ethernet connector to flash.
5.9.2 The All Traffic/CPU Traffic Panes
Click the
Enable Stats
check box to display information on traffic through the module.
Note:
Ethernet pages 1 & 2 refer to the rear-panel Ethernet connectors only. See section 5.20 for
information on managing the on-module Ethernet connector.
Figure 22
Ethernet 1 Page
