IQMIX25/26/40/41
RollCall Control Panel
Issue 1 Rev 4
Page 50
© 2017 SAM
5.17.4 RollTrack Address
This item enables the address of the selected destination unit to be set.
The address may be changed by typing the new destination into the text field, then clicking
S
to save the selection. Clicking
P
returns to the default preset destination.
The RollTrack address consists of four sets of numbers, for example,
0000:10:01*99
:
•
The first set, 0000, is the network segment code number.
•
The second set, 10, is the number identifying the (enclosure/mainframe) unit.
•
The third set, 01, is the slot number in the unit
•
The fourth set, 99, is a user-definable number that is a unique identifier for the
destination unit in a multi-unit system. This ensures that only the correct unit will
respond to the command. If left at 00, an incorrectly fitted unit may respond
inappropriately.
5.17.5 RollTrack Command
This item enables a command to be sent to the selected destination unit.
The command may be changed by typing a code in to the text field, and then selecting
S
to
save the selection. Clicking
P
returns to the default preset command.
A RollTrack command consists of two sets of numbers, for example:
84:156
:
•
The first number, 84, is the actual RollTrack command.
•
The second number, 156, is the value sent with the RollTrack command.
5.17.6 RollTrack Sending
A message is displayed here when the unit is actively sending a RollTrack command.
Possible messages are:
5.17.7 RollTrack Status
A message is displayed here to indicate the status of the currently selected RollTrack index.
Possible RollTrack Status messages are:
Message
Description
No
The message is not being sent.
Yes
The message is being sent.
RollTrack Source
Description
OK
RollTrack message was sent and received successfully.
Unknown
RollTrack message has been sent but transmission has not
yet completed.
Timeout
RollTrack message has been sent but acknowledgement
not received. This could be because the destination unit is
not at the location specified.
Bad
RollTrack message has not been correctly acknowledged at
the destination unit. This could be because the destination
unit is not of the type specified.
Disabled
RollTrack sending is disabled.
