- 44 -
19. When fixing this product using the through hole in the mounting orientations shown below, be
sure to use two side holders as shown in the figure below.
Otherwise, the product will be in an unbalanced state, causing looseness.
20. The product should be mounted as shown below in the figures marked with the
○
.
Unstable mounting of the product may cause operation failure, generation of abnormal noise or
increase in the deflection etc.
21. Even with the same product number, the table of some products can be moved by hand
and the table of some products cannot be moved by hand. However, there is no
abnormality with these products. (Without lock)
This difference is caused because there is a little variation with the positive efficiency (when the table
is moved by the motor) and there is a large variation with the reverse-efficiency (when the table is
moved manually) due to the product characteristics. There is hardly any difference among products
when they are operated by the motor.
○
○
×
×
Body fixed
/ Ceiling mounting (through-hole)
Body fixed
/ Wall mounting (through-hole)
Body fixed
/ Vertical mounting (through-hole)
5mm or less
5mm or less
5
mm o
r le
ss