- 43 -
Body fixed / Side mounting (Side holder)
When installing this product using side holders, use dowel pins for location product.
If vibration or excessive external force is applied to the product, it can cause displacement of the
product if dowel pins are not used.
14. In pushing operation, set the product to a position of at least 0.5mm away from a work piece.
If the product is set to the same position as a work piece, the following alarm and unstable operation
can occur.
a. “Posn failed” alarm
The product cannot reach a pushing start position due to the deviation of work pieces in
width.
b. “Pushing ALM” alarm
The product is pushed back from a pushing start position after starting to push.
15.
Please decrease the transportation mass when the outside power hangs in the table.
Please note might the increase of the sliding resistance of the table when the piping duct etc. are set up in
the actuator, and becoming a defective factor for operation enough.
16. When installing this product using side holders, they should be installed within the range of the
dimensions shown below.
Otherwise, the product will be in an unbalanced state, causing looseness.
17. Do not peel off, and grip the masking tape on the back of the body of LESH*D.
The masking tape peels off, and the foreign body might enter in the actuator.
18. As for LESH*D, when the table operates, the space can be done between motor flanges (figure
below arrow part). Do not place the hand and the finger, etc. because it is dangerous and do not
crowd.
Part no.
Bolt
Max.tigtening torque
[Nm]
l [mm]
LESH8D
M4X0.7
1.5
6.7
LESH16D
M5X0.8
3
8.3
LESH25D
M6X1
5.2
14
l
5mm
or
le
ss
Dowel pins
Part no.
L[mm]
LESH8D□-50
20 ～ 30
LESH8D□-75
50 ～ 60
LESH16D□-50
20 ～ 30
LESH16D□-100
85 ～ 100
LESH25D□-50
25 ～ 35
LESH25D□-100
70 ～ 100
LESH25D□-150
160 ～ 180