SMC Networks HRSH090 Series, Operation Manual

Page: 24 / 194

HRX-OM-R026
Chapter 3 Transport and Setting Up
3.2 Installation HRSH Series
3-4
3.2 Installation
3.2.1 Environment
The product must not be operated, installed, stored or transported in the
following conditions. Potential malfunction or damage to the product may
occur if these instructions are disregarded.
The product does not conform to any clean room specifications. The pump
and ventilating fan inside the product generate particles.

In a location that is exposed to water, water vapor, steam, salt water or oil.

Location that is exposed to dust or powder material.

Location that is exposed to corrosive gas, organic solvent, chemical
solution, or flammable gas (the product is not explosion-proof)

Location where the ambient temperature is out of the following range:
In transportation and In storage 0 to 50°C
(Should not be water or circulating fluid circuit in the product)
In operation 5 to 45°C(Use 15% ethylene glycol
aqueous solution if operating in a place where the circulating fluid temp. or
ambient temperature is lower than 10
°C.)

Location where condensation forms on the inside electrical parts.

Location that is exposed to direct sunlight or heat radiation.

Location that is near heat sources and poor in ventilation.

Location that is subjected to abrupt changes in temperature.

Location that is subjected to strong electromagnetic noise (intense electric
field, intense magnetic field, or surges).

Location that is subjected to static electricity, or conditions where static
electricity can discharge to the product.

Location that is subjected to strong high frequencies raditation
(microwaves).

Location that is subjected to potential lightning srtike.

Do not set up the product in places possibly exposed to leakage of
flammable gas. Should any flammable gas stay around the
product, the product may cause a fire.

Do not use the product outdoors. If the product subjected to rain
orwater splash it may cause electrical shock, fire or failure.

Keep the product horizontal to a rigid and flat floor which can
resist the weight of the product, and take measures to prevent the
product from tipping over. Improper installation may cause water
leakage, tipping, damage of the product or injure the operator.

Keep the ambient temperature of the product between 5 to 45
o
C.
Operation out of this ambient temperature range may cause a
malfunction of the product.

The installer/end user is responsible for carrying
out a acoustic noise risk assessment on the equipment after
installation and taking appropriate measures as required.