SMC Networks 6128PL2, Management Manual

Page: 461 / 664

SNMP Commands
4-153
4
Related Commands
snmp-server location (4-153)
snmp-server location
This command sets the system location string. Use the no form to remove the
location string.
Syntax
snmp-server location text
no snmp-server location
text - String that describes the system location.
(Maximum length: 255 characters)
Default Setting
None
Command Mode
Global Configuration
Example
Related Commands
snmp-server contact (4-152)
snmp-server host
This command specifies the recipient of a Simple Network Management Protocol
notification operation. Use the
no form to remove the specified host.
Syntax
snmp-server host host-addr [ inform [ retry retries | timeout seconds ]]
community-string [ version { 1 | 2c | 3 { auth | noauth | priv } [ udp-port port ]}
no snmp-server host host-addr
• host-addr - Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
• inform - Notifications are sent as inform messages. Note that this option is
only available for version 2c and 3 hosts. (Default: traps are used)
-
retries - The maximum number of times to resend an inform message if
the recipient does not acknowledge receipt. (Range: 0-255; Default: 3)
- seconds - The number of seconds to wait for an acknowledgment before
resending an inform message. (Range: 0-2147483647 centiseconds;
Default: 1500 centiseconds)
• community-string - Password-like community string sent with the
notification operation to SNMP V1 and V2c hosts. Although you can set this
string using the
snmp-server host command by itself, we recommend that
Console(config)#snmp-server location WC-19
Console(config)#