SMARTEYE Multi-netx, User Manual

Page: 31 / 76

SMARTEYE
Netx Ethernet IP Control Unit User Manual Page 25
Filename: netx IP Platform User Manual R0 .doc
…
In Control
A
M
5. Finish any other configuration changes that are required and click the ‘APPLY
CHANGES’ link to save the configuration in flash memory. The configuration
parameters will be retained even after power is removed from the unit. After the settings
are applied, the control unit will reboot with the new IP address. After rebooting we will
not be able to web page to the control unit because the assigned IP no longer matches our
PCs network. The Smarteye Netx Control Unit can now be installed on the plant’s
network.
Repeat this process for each Smarteye Netx Control Unit that needs to be configured.
8.2 Software Configuration Using the Auxiliary Port
The Smarteye Netx Control Unit must be connected serially to either a terminal or a COM port
on a computer using a standard 9 pin RS232 serial cable. For the auxiliary port interconnection
diagram, refer to the Auxiliary Port Wiring Details in the appendix. The Netx Control Unit does
not need to be connected to the network for Auxiliary Port configuration.
If connected to a computer, then a terminal emulator program such as Hyper Terminal will be
required. The terminal settings should be 57600-baud, eight data bits, no parity, and one stop bit.
Once the control unit is physically connected to a terminal or PC, it can be powered up.
Provided the Smarteye Netx Control Unit is not in Bluetooth mode, similar information to the
following will be displayed on your PC or terminal though the COM port when the unit is
powered up.
SMARTEYE Version 2.6.1e Build: 04-DEC-2012
Boot Loader Version 1.56
Using setup parameters saved in flash
Configuration
Description: Smarteye – New Reader
MAC Address: 0050C22C21CF
DHCP: Yes
IP: 192.168.22.243
Mask: 255.255.255.0
Gateway IP: 192.168.22.1
Time Zone: -5:00
Time Server IP: 0.0.0.0
Time Server Freq: 60