Ski-Doo MX Zx 600 RS, Operator'S Manual

Page: 84 / 123

MAINTENANCE PROCEDURES
WARNING
If fuse has burnt out, source of mal-
function should be determined
and corrected before restarting.
See an authorized Ski-Doo dealer
for servicing.
Fuse Location
The fuse holder is located on the RH
side of the engine compartment near
the chaincase.
To access the fuse holder, refer to body
and open the RH side panel.
mmo2009-009-011_a
1. Fuse holder location
Lights
Always check light operation after bulb
replacement.
Headlights Bulb Replacement
NOTICE
Never touch glass portion
of an halogen bulb with bare fingers,
it shortens its operating life. If glass
is touched, clean it with isopropyl al-
cohol which will not leave a film on
the bulb.
By using a small screwdriver, release
multifunction gauge locking tabs.
mmo2007-009-061_a
1. Locking tab
Gently pull on multifunction gauge and
set aside.
mmo2007-009-062_a
Disconnect burnt bulb connector. Re-
move the rubber boot.
mmo2007-009-022_a
1. Rubber boot
Press and pull both sides of the retain-
ing clip at the same time to release it
from bulb support.
82
______________