Ski-Doo MX Zx 600 RS, Operator'S Manual

Page: 74 / 123

MAINTENANCE PROCEDURES
To add oil, remove the filler cap on
chaincase cover.
mmo2009-003-009_a
1. Filler cap
Pour recommended oil in chaincase by
the filler hole until oil comes out by the
magnetic check plug hole. Reinstall
magnetic check plug and torque to
6 N•m ± 1 N•m (53 lbf•
in ± 9 lbf• in ).
Drive Belt Guard
Drive Belt Guard Removal
WARNING
NEVER operate engine:
– Without shields and belt guard
securely installed
– With hood and/or side panels
opened or removed.
NEVER attempt to make adjust-
ments to moving parts while en-
gine is running.
NOTE: Belt guard is purposely made
slightly oversize to maintain tension on
its pins and retainers preventing undue
noise and vibration. It is important that
this tension be maintained when rein-
stalling.
Remove the tether cord cap.
Open engine compartment LH side
panel, refer to
BODY .
Remove retaining pin.
mmo2008-007-016_a
1. Retaining pin
Lift rear portion of guard then release
from upper retaining pin.
Release guard from the front tabs by
pivoting the guard outwards.
Drive Belt Guard Installation
When reinstalling belt guard, position
its cutaway toward front of snowmo-
bile.
Place the front LH slot of the guard
over the longest tab.
Pivot the guard inward to engage the
shortest tab in the RH slot.
mmo2009-003-010_a
1. Tabs
Position the grommet over the retain-
ing rod. It may be necessary to slightly
lift the console to make room.
72
______________