Ski-Doo MX Zx 600 RS, Operator'S Manual

Page: 70 / 123

MAINTENANCE PROCEDURES
This section includes instructions for
basic maintenance procedures. If you
have the necessary mechanical skills
and the required tools, you can per-
form these procedures. If not, see
your authorized Ski-Doo dealer.
Other important items in the mainte-
nance schedule that are more difficult
and require special tools are best per-
formed by your authorized Ski-Doo
dealer.
WARNING
Turn off the engine, remove tether
cord cap and follow these mainte-
nance procedures when perform-
ing maintenance. If you do not
follow proper maintenance pro-
cedures you can be injured by hot
parts, moving parts, electricity,
chemicals or other hazards.
WARNING
Should removal of a locking device
(e.g. lock tabs, self-locking fasten-
ers, etc.) be required when un-
dergoing disassembly/assembly,
always replace with a new one.
Throttle Position Sensor
(TPS)
Throttle Position Sensor Reset
To reset TPS, proceed as follows:
1. Refer to
BODY
and open the RH
side panel.
2. Remove the 6-pin vehicle connector
from its protective cap on the RH
side.
3. Connect the T-HARNESS (P/N 529
035 869) on the 6-pin connector.
4. Connect the T-harness to a 12 V bat-
tery using the 12 V BATTERY SUP-
PLY CABLE (P/N 529 035 997).
NOTICE
Respect battery polarity.
Install the RED probe on the positive
battery post, then the BLACK probe
on the negative battery post.
mmo2009-009-012_a
1. 6-pin connector
2. T-harness
3. 12 V battery supply cable
5. Fully depress throttle lever (wide
open position) and hold.
6. Depress the pre-heat switch for 5
seconds until beeper sounds.
7. Release throttle and pre-heat
switch.
8. Unplug battery and cables, close
side panel.
Air Filter
Air Filter Verification
Ensure that air intake filter is properly
installed, clean and in good condition.
68
______________