Ski-Doo 2005 REV series, Operator'S Manual

Page: 253 / 283

TROUBLESHOOTING
Monitoring Beeper Coded Signals
2 short beeps (when engine is started) then engine stops.
1. Engine stops automatically after four minutes of idling (without de-
pressing the throttle handle) and engine temperature higher than
85°C (185°F).
–
Depressing throttle lever within four minutes will reset timer
to four minutes.
2 short beeps (when engine is started).
DESS/RER pilot lamp also blinks.
1. Confirms that proper tether cord cap is installed. Engine can rev
above pulley engagement.
–
Normal condition.
1 short beep every 1.5 seconds (when engine is started).
DESS/RER pilot lamp also blinks.
Engine cannot reach pulley engagement speed. Vehicle cannot
be driven.
1. Bad DESS system connection.
–
Reinstall tether cord cap correctly over post.
2. Defective tether cord cap.
–
Use another programmed tether cord cap.
3. Dirt or snow in tether cord cap.
–
Clean tether cord cap.
4. Defective DESS post.
–
Replace DESS post.
1 long beep per second.
1. Reverse is selected.
–
Vehicle can be driven in reverse.
3 short beeps per second. DESS/RER pilot lamp also blinks.
Engine cannot reach pulley engagement speed. Vehicle cannot
be driven.
1. Wrong tether cord cap is installed.
–
Install proper tether cord cap. Program key into electronic
module.
_________________________
251