Ski-Doo 2005 REV series, Operator'S Manual

Page: 182 / 283

2-TEC Models (Manual Starting)
Initial Cold Starting and Warm Engine Starting
Push on the START/RER button once to energize the ECM and
gauges, this will ease the starting.
NOTE: If the small battery is low or dead, the ECM and gauges can-
not be energize before starting.
Grab starter handle firmly and crank engine.
IMPORTANT: If the small battery is low or dead it is still possible to
start the engine, in this case, the pull on the rewind starter must be
long (full length of rope).
2-TEC Models (Electrical Starting)
Initial Cold Starting and Warm Engine Starting
Use electric starter.
IMPORTANT: If the low battery voltage pilot lamp is on, battery
would not have enough power to start the engine. In this case, use
the manual rewind starter.
If the battery is dead, engine cannot be started. Have the battery
recharged or replaced.
4-TEC Models
Initial Cold Starting and Warm Engine Starting
Use electric starter.
IMPORTANT:
On 4-TEC models if the battery is dead, engine cannot
be started. Have the battery recharged or replaced.
NOTE: There is no manual rewind starter on 4-TEC models.
Manual Starting
All Models except 4-TEC
NOTE: There is no manual rewind starter on 4-TEC models.
On fan-cooled models, insert the key in the ignition switch and turn
to ON position.
Except for 2-TEC models, activate the choke according to the tem-
perature as explained above.
180
_________________________