SKF TLGB 20, Instructions For Use Manual

Page: 96 / 421

Service parts/kits list
Item Description Part number Qty
1 Grease tube assembly TLGB 20-4 1
2 Flexible hose kit TLGB 20-3
2.1 Cap 1
2.2 Coupling 1
2.3 Flexible hose 36 in.(
914 mm
) with gasket 1
3 Battery pack 20 V (lithium) TLGB 20-2 1
NS* Battery charger (lithium) 220-240 volt TLGB 20-5 1
NS Battery charger (lithium) 110 volt TLGB 20-6 1
NS Shoulder strap TLGB 20-1 1
*
Not shown
Troubleshooting
Condition Cause Corrective action
Grease gun fails to dispense grease. Grease tube assembly is out of grease. Check that grease tube assembly has grease.
Repeat priming operation.
Loss of prime. Remove ball check (
16
), clean and inspect ball
seat area.
Ball check (
16
) is not functioning. Clean or replace whip hose. Remove blockages.
Clogged whip hose. Clean or replace whip hose.
Display flashing red due to motor overload. Blocked lube point. Clean or replace whip hose.
Clogged whip hose. Empty grease tube assembly, refill and repeat
priming instructions.
Grease gun continues to lose prime. Air trapped in several locations in container after bulk
filling.
Disassemble grease tube assembly and clean. Be
sure that follower has properly entered the
grease cartridge.
Follower binding in grease tube assembly. Disassemble grease tube assembly and clean. Be
sure that follower has properly entered the
grease cartridge.
Verify that the follower is not caught on the rim of
the grease cartridge.
Replace grease tube assembly (14) if damaged.
Check ball seat
(
16
)
and check ball dirty. Clean check ball
(
16
)
and check ball seat.
Battery fails to take a charge. No power to charger. Check that receptacle has power.
Battery may be bad. Replace battery.
Battery needs charging Recharge battery.
Motor fails to run. Faulty wiring to motor. Remove battery, disassemble handle and check
wiring connections on terminal, trigger switch
and motor.
15