SKF TLGB 20, Instructions For Use Manual

Page: 88 / 421

Do not charge SKF TLGB 20-2 battery
packs with any other charger.
To reduce risk of injury, SKF TLGB
20-5 and TLGB 20-6 chargers should
only be used to charge SKF TLGB 20-2
battery packs. Other types of batteries
may burst.
Failure to comply may result in serious
personal injury or death.
D A N G E R
The charger is intended
for indoor use only.
Read the instruction
manual before use.
Charger is double insulated;
therefore no ground wire is
required. Always check mains
voltage corresponds to voltage
on rating plate.
Never attempt to replace
charger unit with a regular
mains plug.
Charger
• Before using a battery charger, read all
instructions and cautionary markings on
battery charger, battery pack, and product
using battery.
• Do not expose charger to rain, snow or
frost.
• Do not abuse cord. Never carry charger by
cord or pull on it to disconnect from
receptacle. Pull by plug rather than cord
when disconnecting charger. Have dam-
aged or worn power cord and strain
reliever replaced immediately. Do not
attempt to repair power cord.
• Make sure cord is located so that it will not
be stepped on, tripped over, or otherwise
subjected to damage or stress.
• Do not use an extension cord unless
absolutely necessary. Use of improper
extension cord could result in a risk of fire
and electric shock.
• Do not operate charger with damaged
cord or plug. Replace immediately, to avoid
a hazard. Do not attempt to repair power
cord.
• Do not operate charger if it has received a
sharp blow, been dropped, or otherwise
damaged in any way, take it to a qualified
service center.
• Do not disassemble charger or battery
pack. Take it to a qualified service center
when service or repair is required.
Incorrect reassembly may result in risk of
electrical shock or fire.
• Unplug charger from outlet before
attempting any cleaning to reduce risk of
electric shock.
• Charge the battery pack in a well ventilat-
ed place; do not cover the charger and
battery with anything while charging.
• Do not store the charger or battery packs
in locations where the temperature may
reach or exceed 50 °C
(122 °F)
such as a
metal tool shed, or a car in the summer
which can lead to deterioration of the
battery.
• Do not charge battery pack when the
temperature is below 5 °C
(40 °F)
or
above 40 °C
(105 °F)
. This is very impor-
tant for proper operation.
• Do not incinerate battery pack. It can
explode in a fire.
• Do not charge battery in damp or wet
locations.
• Do not short across the terminals of the
battery pack. Extremely high tempera-
tures could cause personal injury or fire.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities.
Do not use this appliance if not experi-en-
ced or have knowledge of how it operates.
• Dispose of expended batteries properly.
The SKF TLGB 20-2 battery pack contains
rechargeable, lithium-ion batteries. These
batteries must be recycled or
disposed of properly. Drop off expended
battery packs at your local replacement
battery retailer, or your recycling center.
Electrical safety
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorized SKF service center in order to
avoid a hazard.
7