SKF ST-1240-GRAPH, Manual

Page: 14 / 43

14
Transport, installation, maintenance, malfunctions, repairs, shutdown for
maintenance and disposal
"
All relevant persons must be informed of the activity prior to starting any work. Observe safe operating measures and
work instructions.
"
Transport the products with suitable transportation and hoisting equipment using suitable work methods.
"
Before conducting any work, depressurise the product or machine to which the product has been connected and
secure it against unauthorised activation.
"
Unauthorised persons must be kept away
"
Ensure through suitable measures that movable or detached parts are immobilised during the work and that no limbs
can get caught in between if there are any inadvertent movements.
"
Assemble the product outside of the operating range of moving parts, at an adequate distance from any sources of
heat or cold. Be careful not to damage other units in the machine or vehicle or to impair their functionality during
installation.
"
Dry up or cover any wet, slippery surfaces.
"
Cover any hot or cold surfaces.
"
Work on electrical components must be carried out by an electrician. Observe any waiting periods for discharging, if
necessary. Carry out work on electrical components using voltage insulated tools only.
"
Make electrical connections only according to the information in the valid wiring diagram and taking the relevant
regulations and the local connection conditions into account.
"
Do not touch cables or electrical components with wet or damp hands.
"
Do not bypass any fuses. Replace any blown fuses with fuses of the same type and rating only.
"
Do not drill holes into critical, load-bearing parts. Use existing boreholes whenever possible. Be careful not to damage
lines and cables when drilling.
"
Observe any abrasion points. Protect the parts accordingly.
"
All components used must be suitable for use at
3 the system9s maximum operating pressure; and
3 the system9s minimum and maximum ambient temperature.
"
Do not subject any parts of the centralised lubrication system to torsion, shear or bending.
"
Before using any parts, check them for contamination, clean if necessary.
"
Lubricant lines should be primed with lubricant prior to installation. This makes it easier to bleed the system of air
afterwards.
"
Observe the specified tightening torques. Use a calibrated torque wrench.
"
When working with heavy parts, use suitable lifting tools.
"
Avoid mixing up or wrong assembly order of dismantled parts. Mark these parts accordingly.
"
If guards or safety devices need to be removed, they must be reinstalled immediately following conclusion of work and
then checked for proper function.
First start-up, daily start-up
Ensure that:
"
All safety devices are fully present and functional
"
All connections are properly connected
"
All parts have been correctly installed
"
All warning labels on the product are fully present, visible, and undamaged
" Illegible or missing warning labels are immediately replaced.
Cleaning
"
There is a risk of fire and explosion when using flammable cleaning agents. Only use non-flammable cleaning agents
suitable for the purpose
"
Do not use any aggressive or corrosive cleaning agents.
"
Do not use a steam jet or a high pressure cleaner to clean the device. Electrical components may be damaged.
Observe the IP protection class.
"
Cleaning work on energised components may be carried out by electricians only.
"
Mark damp areas accordingly.