EN
6. Assembly
6
- 77 -
951-180-076-EN
Version 0y
-See Figure 26
• Deburr the connecting end of the lubri-
cation line (
1
).
• Remove the union nut (
2
) and cutting
sleeve (
3
) from the ring piece (
4
).
• Insert the lubrication line (
1
) into the
union nut (
2
) and cutting sleeve (
3
).
• Insert the lubrication line (
1
), union nut
(
2
), and cutting sleeve (
3
) into the ring
piece (
4
).
• Apply the union nut (
2
) to the
thread of the ring piece (
4
) and gently
tighten the union nut (
2
) by hand.
• Tighten the union nut (
2
) with an open-
end wrench.
1
2
3
4
6.8.1 Assembly of the lubrication lines
Legend to
Fig. 21
Item
Deschiption
1
Lubrication line to match pipe connection
2
Union nut
3
Cutting sleeve
4
Ring piece
be placed at the end of the main lubri-
cant line.
○
The flow of lubricant should not be
impeded by the incorporation of sharp
bends, angle valves, flap valves, seals
protruding inward, or changes in cross-
section. Unavoidable changes in the
cross-section in lubrication lines must
have smooth transitions.
○
Use only grounded steel pipelines.
Fig.26
Lubhication line connection
