- 24 -
951-180-076-EN
Version 0y
EN
1. Safety instructions
Residual risk
Possible in
lifecycle
Avoidance / Remedy
Use in a potentially explosive atmo-
sphere without checking equipotential
bonding for electrical continuity
C, D, G
Check the equipotential bonding for continuity before initial commissioning, after every repair,
and additionally at regular intervals defined by the operator
Use with a damaged, incorrect, or miss-
ing finish
C, D, E, F, G
Prior to initial commissioning and then at regular intervals, inspect the varnishing and if neces-
sary have it replaced by a person competent to do so
Heating of non-supplied lubrication
points to the ignition temperature range
by an undetected malfunction within the
centralized lubrication system
C, D, G
The operator must critically examine whether operation without corresponding detection options
results in a new hazard potential (e.g., due to heating of non-supplied bearings on the machine
to the range of the ignition temperature); if this cannot be reliably excluded, take appropriate
countermeasures
Heating of components to the ignition
temperature range / formation of a
potentially explosive atmosphere by agi-
tated/swirled dust
C, D, E, F, G
Avoid accumulated dust / remove accumulated dust on a regular basis; select an installation
location
with the lowest possible dust level
Lifecycles: A = Transport, B = Assembly, C = Initial commissioning, D = Operation, E = Cleaning, F = Maintenance, G = Malfunction, repair,
H = Shutdown, K = Disposal
1.27 Residual ATEX risks
