Simrad SP60 - REV D, Installation Manual

Page: 76 / 218

Simrad SP60
60
851-164574 / C
7.4 Wheelhouse cabling
Introduction
Connections to the Sonar Processor Unit are made on the
connectors on the rear side of the unit. The fixed connectors are
specified on the identification panel, while the circuit board
connectors are identified with
Jx tags.
Note
The Sonar Processor Unit provides a large number of connectors
that are not used by the SP60 sonar.
Connections to the Sonar Interface Unit are made on the terminal
blocks and connectors on the main circuit board. To access to
connectors, open the unit’s lid. An identification panel is available
inside the Sonar Interface Unit.
For connection of the peripheral equipment, refer to section
Peripheral equipment .
→
Refer to page 75.