Simrad SP60 - REV D, Installation Manual

Page: 17 / 218

Introduction
1
851-164574 / C
1 INTRODUCTION
1.1 Purpose and description
Introduction
The purpose of this manual is to provide the information and basic
drawings required for installation of the Simrad SP60 sonar
system.
These instructions must be followed carefully to ensure optimal
sonar performance. As a guide, installation procedures are
presented in the order they are to be performed. Successful
completion of each procedure is to be confirmed by checking-off
the corresponding box.
After installation, this document should be stored on board the
vessel for later reference when updating or servicing the
equipment.
Note
The installer is responsible for the equipment during the
installation. The guarantee is only valid when the installation is
made in accordance with this manual.
Installation procedures
Installation procedures for the standard Simrad SP60 sonar system
can be grouped under the following main categories:
→
Installation planning, page 22.
→
Installation trunk, page 29.
→
Hull Unit, page 34.
→
Transceiver Unit, page 42.
→
Wheelhouse Units, page 46.
→
Cabling, page 55.
→
Peripheral equipment, page 75.
→
Start-up procedures, page 87.
→
Testing the peripheral equipment, page 124.
→
Final tests and measurements, page 138.