Simrad SP60 - REV D, Installation Manual

Page: 30 / 218

Simrad SP60
14
851-164574 / C
- “Special circumstances” may be suspected damage to the
crate and its content, or inspections by civil authorities.
- If any units are damaged, prepare an inspection report
stating the condition of the unit and actions taken.
Describe the damage and collect photographic evidence
if possible. Re-preserve the equipment.
- If the units are not damaged, check the humidity
absorbing material. If required, dry or replace the bags,
then repack the unit(s) according to the packing
instructions.
7 If the crate has been opened, make sure that is it closed and
sealed after the inspection.
- Use the original packing material as far as possible.
→
Refer to the information on page 19.
Ambient temperature and humidity
1 The storage room/area must be dry, with a non condensing
atmosphere. It must be free from corrosive agents.
2 The storage area’s mean temperature must not be lower than
-30
°
C, and not warmer than +70
°
C.
- If other limitations apply, the crates will be marked
accordingly.
Note
Transducers must not be stored in temperatures below -20
°
C.
3 The crate must not be exposed to moisture from fluid
leakages.
4 The crate must not be exposed to direct sunlight or excessive
warmth from heaters.
Shock and vibration
1 The crate must not be subjected to excessive shock and
vibration.
- Normal vibrations from vehicle, vessel or other
transportation movements are permitted.
ESD precautions
→
Refer to the information on page 20.
Batteries
If the unit contains normal batteries, these may have been
disconnected/isolated before the unit was packed. These must only
be reconnected before the installation starts. Units containing
batteries are marked.
Caution
Units containing lithium or alkaline batteries must be handled
separately and with care. Such units are marked accordingly. Do
not attempt to recharge such batteries, open them or dispose of
them by incineration. Refer to the applicable product data sheets.