Simrad SP60
136
851-164574 / C
10.9 Radio buoy system
Observe the following procedure to test the radio buoy system
interface.
1
Access the
I/O Setup
menu.
→
A procedure for this is located on page 125.
2
Select
Sensors
in the
I/O Setup
menu, then
BuoySystem
,
and finally
Buoy NMEA
.
3
Observe the
Sensor Config
submenu appears at the bottom
of the menu field.
4
Check that the settings in the
Sensor Config
submenu
correspond to your requirements for the serial line.
5
Press
Close
to exit the
Sensor Config
menu.
6
Select the
Objects
menu, and check that the Buoy readout
(
F
) is shown.
7
Select one of the buoys in the
Objects
menu, and verify that
the buoy data is shown in the dialogue below the menu.
Summary of Contents for SP60 - REV D
