Operational procedures
69
850-165085 / Rev.B
Sensor setup
Observe the procedure below to set up a Twin Spread
configuration with its default settings.
In this procedure, sensors 1 and 2 are used, and no other sensors
are shown. Due to the fact that the Twin Spread sensor occupy
two communication channels, the setup program requires that it
is configured as if it was two separate sensors, but not
necessarily sensors 1 and 2. The remaining four channels can be
used for other sensors.
We strongly suggest that you use the forms in the front of this
manual to write down the sensor you have with information
about their update rates and communication channels.
1
Press the
MENU
button to open the main menu.
2
Open the
Setup
menu (4), and select
Sensor setup
(5).
3
Press the
ENT
key to bypass the warning page.
4
To configure the Twin Spread sensor, enter the following
parameters:
a
Set
Sensor 1
type to SINGLE to activate the sensor.
b
Set
Update 1
rate to FAST.
c
Set
Measure 1
to SPREAD.
d
Set
Channel
to 02.
e
Set
Sensor 2
type to SINGLE to activate the sensor.
f
Set
Update 2
rate to FAST.
g
Set
Measure 2
to SPREAD.
h
Set
Channel
to 07.
5
For operational use, make sure that
Demo mode
is set to
OFF.
6
When you have defined the sensors, press the
ENT
buttom to save the changes and exit.
