Simrad PI44
54
850-165085 / Rev.B
Position display
The
Position display
provided by the PI44 offers all key
information related to safe navigation on one display
presentation. Note that the information provided by the
Position
display
assumes that you have the relevant sensors (GSP and
temperature feeler) connected to your PI44 system.
The
Position display
can be set up as a full screen feature, but
you can also set it up to be displayed in smaller windows.
The following information is
provided by the position
display:
Water temperature:
The
temperature will only be
available if the applicable
temperature feeler is connected
to the PI44.
Two individual distance logs:
Both distance logs can be reset
using the setup parameters.
Current geographical
position:
If the position fails to
be updated, the characters will
flash.
Current speed, course and depth:
This information will only
be available if the applicable sensors have been connected to the
PI44.
Local time and date
External POS:
This is the current status of the satellite
reception. The character “A” means that the reception is good,
“B” means that the reception is acceptable, and “C” means that
it is poor. If there is no reception, the message
Not valid
will be
shown.
To change presentation parameters
The presentation is controlled by the parameters defined in the
PI44 setup. To change these parameters, press the
ADJ
or
ENT
buttons to open the
Position display setup
page. To access the
Pilot/Position
parameters, press the
MENU
button to access the
main menu. Then. select
Pilot/Position Setup
on the
Setup
menu.
Related topics
→
Position display setup, page 206
→
Pilot/Position setup, page 200
