Silca Triax Quattro, Operating Manual

Page: 62 / 118

Operating Manual - English Triax QUATTRO
- 54 - Copyright Silca 2011
1
5.10.4
AUTOMATIC CALIBRATION OF TRACER TOWER DEVICE
The TRACER TOWER decoding device holds 2 types of tracer points: U102TT and U103TT.
These 2 tracer points are used by Triax QUATTRO, as a stand-alone or with a PC, to decode almost all the
systems/locks known by Silca S.p.A.
Use of the TRACER TOWER speeds up and simplifies the cutting of original keys.
The operator can avoid:

searching for and choosing the appropriate decoder;

replacing the cutter with a tracer point to start decoding;

replacing the tracer point with the cutter when decoding is over, to prepare for cutting the key.
The machine program is prepared to perform calibration and decoding with either the TRACER TOWER or a
tracer point fitted in the place of the cutter.
Simply enable or disable the TRACER TOWER from the “OPTIONS” menu.
The TRACER TOWER must be CALIBRATED before use.
The TRACER TOWER calibration procedure is carried out only with clamp R1 already calibrated.
Manual adjustments and settings from -30 to +30 hundredths of mm.
Press START to proceed.
Set clamp R1, lower the Tracer Tower.
N.B. Carefully clean clamp R1.
ATTENTION!
ELIMINATE SWARF FROM
CLAMP R1.
START to proceed with calibration.
When calibration is finished the display will show the differences in the
values read.
Calibration will be accepted only if the size of the variations is between
+50 and -50 hundredths of millimetre.
ENTER
to confirm.
STOP to cancel