Silca Triax Quattro, Operating Manual

Page: 30 / 118

Operating Manual - English Triax QUATTRO
- 22 - Copyright Silca 2011
1
4.5
CHANGING THE CUTTER/DECODER
To remove a decoder or cutter from the spindle, raise the safety shield and proceed as follows:

Block spindle rotation by lowering the lever (B2-Fig. 20).

With one hand hold the cutter or decoder to be removed.

With the other hand push the knob down (B1-Fig. 20) and turn anticlockwise until the tool is released.

Remove the tool.
To fit a tool proceed as follows:

Block spindle rotation by lowering the lever (B2 –Fig. 20)

Fit the tool into spindle and push all the way in.

Hold the tool in place with one hand and with the other lower and turn the knob (B1-Fig. 20) clockwise.

Release spindle rotation by raising the lever (B2 –Fig. 20).
ATTENTION: when commencing a process with START, if the lever remains blocked, the following
message appears:
SPINDLE ALARM
check tool and lever
position ( XX)
B1
B2
Fig. 20