SII DPU-S245, Technical Reference

Page: 31 / 170

4-4
4.1.2 Function Settings(SWDIP2)
Table 4-2 Function Settings (SWDIP2)
Value
SWDIP Function
0 1
2-8 Auto Status Output Enable
Disable
2-7 Kanji Code Shift-JIS Code JIS Code
2-6 Font Size 16 dots 24 dots
2-5 Auto Power Off Enable Disable
2-4 Character Set IBM Compatible ANK
2-3 Reserved Fix to 1
2-2
2-1
Data Input Mode See below

Auto Status Output selection
When Auto Status Output selection sets to Enable, the printer sends printer status to the host
device every one second.
Refer to the descriptions of Automatic Status Response (DC2 'e') command for the code to be sent.
Moreover, refer to 6.7 INITIAL AUTOMATIC STATUS TRANSMISSION for more details.
(NOTE) When this function set to Enable, the printer keeps on storing data into the
transmission buffer if the printer status is not received.
The condition of the transmission buffer as buffer full may not work because
status data can not be created. Note that the printer does not perform printing
processing until the transmission buffer full is cleared.

Kanji Code selection
Select Kanji Code in default as JIS Code or Shift-JIS Code. This setting can be changed by Select
Kanji code system (FS 'C') command (6.5.11 Kanji Character Set Selection Command).

Font Size selection
Select Font Size in default as 16 or 24 dots. This setting can be changed by Select character font
size (DC2 'F' ) command (6.5.24 Character Set Command).

Auto Power Off selection
When Auto Power Off selection sets to Enable, the printer turns itself off after passing a set time.
This setting can be changed by Set default/Set test print header (DC2 'i' ) command (6.5.25
Auxiliary Function Commands ). The default value is 30 minutes.

Character Set selection
Select Character Set as IBM compatible or ANK. This setting can be changed by Select character
code table (ESC 't') command (6.5.7 1-byte Character Set Selection Commands). See Appendix A
CHARACTER CODE for character code.