SignWarehouse.com Vinyl Express Qe6000, User Manual

Page: 96 / 246

4-10
The function to cut specified numbers of cutting data stored in the buffer memory is called COPY.
Supplement
Do not send new data to plotter while copying. Cutting data in the buffer memory will be cleared.
Previous cutting data will be cleared and newly sent data will be stored as cutting data if you send new data with 10 seconds or
more interval from the time it finished cutting.
It can not copy if data is more than 1.6 MB because it cannot be stored in the buffer memory of the plotter.
Buffer memory that can be used for copy will decrease if you turn on the data sort. Turn off the data sort when you need to copy
cutting with large data. See "Sorting the Cutting Data"
P.8-2
for data sort.
Watch out that it does not fall out of media when cutting with copy function.
If the original cutting data to be copied starts away from the origin point, copied cutting will also start away from the origin point. To
avoid wasted space, create the cutting data close to the origin point.
Alignment registration mark data cannot be copied.
When Media Change mode is off
Copy is performed in following order.
Origin point
First cut
Copy origin
point
First copy
Third copy
Second copy Fourth copy
Copy space
Copy
space
It will copy in following order when MIRROR is set.
Origin point
First cut
Copy origin point
Second copy Fourth copy
First copy
Third copy
Copy space
Copy
space
4.2
Copy (Duplicate Cutting)