Signature 1100R+, User Manual

Page: 38 / 83

34
Preferences
and Settings
1100 R+ Factory Defaults
The tables below list settings in the 1100R+ and their corresponding Factory Defaults.
User Preferences Factory Defaults
Test Mode CONTINUOUS
External Switch OFF
Fault Location OFF
Auto Start OFF
Test Count Good Only
Auto Print OFF
Digital Outputs Pin 7 = Good Light On
Pin 8 = Bad Light On
Volume Medium
Low Voltage Settings Factory Defaults
Connection Resistance 10.0
Ω
LV Insulation Resistance 100K
Ω
Component Resistance OFF
Restoring Factory Default Preferences and Settings
The factory defaults for User Preferences, Learn Settings, and test settings for the loaded test
may be restored at any time.
1. From the main menu, press
Set Preferences.
2. Scroll down and press
Set Factory Default.
3. Press RESET.
What Happens when a Cable is Tested?
To understand how to set the preferences and settings, you need to have a basic idea of what
happens when a cable is tested.
When the tester is set up with factory default preferences and settings, there are two parts to the
test:
Note: The intermittent test will not occur if the User Preference Test Mode is set to SINGLE.
First Part
Low Voltage Test
The tester checks the
cable for opens, shorts,
and miswires.
Second Part
Intermittent Test
Until the cable is removed,
the tester repeatedly runs
low voltage tests to check
for intermittent errors.
SIGNATURE 1100R+
Set Preferences
Set Up Test Program
TEST: DT Solar