Chapter 11
| Interface Commands
– 362 –
low-alarm
– Sets the low power threshold for an alarm message.
low-warning
– Sets the low power threshold for a warning
message.
threshold-value
– The power threshold of the received signal.
(Range: -4000 - 820 in units of 0.01 dBm)
Default Setting
High Alarm: -3.00 dBm
HIgh Warning: -3.50 dBm
Low Warning: -21.00 dBm
Low Alarm: -21.50 dBm
Command Mode
Interface Configuration (SFP+ Ports)
Command Usage
◆
The threshold value is the power ratio in decibels (dB) of the measured
power referenced to one milliwatt (mW).
◆
Refer to the Command Usage section under the
command for more information on configuring transceiver
thresholds.
◆
Trap messages enabled by the
command are sent to
any management station configured by the
command.
Example
The following example sets alarm thresholds for the signal power received at
port 1.
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-threshold rx-power low-alarm -21
Console(config-if)#transceiver-threshold rx-power high-alarm -3
Console#
transceiver-threshold
temperature
This command sets thresholds for the transceiver temperature which can be
used to trigger an alarm or warning message.
Syntax
transceiver-threshold temperature
{
high-alarm
|
high-warning
|
low-alarm
|
low-warning
}
threshold-value
high-alarm
– Sets the high temperature threshold for an alarm
message.
high-warning
– Sets the high temperature threshold for a warning
message.
