SignaMax 065-7700, User Manual

Page: 174 / 199

Hardened Managed PoE Ethernet Switch
User’s Manual 173
The following example specifies 20 seconds for the Switch to wait for a server
host to reply before timing out:
switch_a(config)#radius-server timeout 20
switch_a(config)#
Retransmit:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to specify the number of times the Switch transmits each
radius request to the server before giving up.
3.
Command Syntax:
radius-server retransmit RETRIES
no radius-server retransmit
RETRIES <1-100> Specifies the retransmit value. Enter a value in the range
1 to 100.
4.
Example:
The following example specifies the retransmit value 12 :
switch_a(config)#radius-server retransmit 12
switch_a(config)#
Port Authentication
Authentication State:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use dot1x reauthetication command to enable reauthentication on a port.
Use no dot1x reauthetication command to disable reauthentication on a
port.
3.
Command Syntax:
(no) dot1x reauthentication