SignaMax 065-7700, User Manual

Page: 144 / 199

Hardened Managed PoE Ethernet Switch
User’s Manual 143
Forward Delay (sec) (4..30):
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set the time (in seconds) after which (if this bridge is the
root bridge) each port changes states to learning and forwarding.
Use the no parameter with this command to restore the default value.
3.
Command Syntax:
bridge GROUP forward-time FORWARD_DELAY
no bridge GROUP forward-time
GROUP <1-1> The ID of the bridge group to which this delay time is
assigned.
FORWARD_DELAY <4-30> the forwarding time delay in seconds.
4.
Example:
The following example sets the forward-time FORWARD_DELAY ( 30 ) of
bridge GROUP ( 1 ):
switch_a(config)#bridge 1 forward-time 30
switch_a(config)#
RSTP Port Setting
Priority(Granularity 16):
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use this command to set the port priority for a bridge. The lower priority
indicates a greater likelihood of the bridge becoming root.
3.
Command Syntax:
bridge GROUP priority PRIORITY
GROUP <1-1> the ID of the bridge group.
PRIORITY <0-240> The priority to be assigned to the group.
4.
Example:
The following example sets the priority PRIORITY ( 100 ) of the interface fe1