SignaMax 065-7700, User Manual

Page: 154 / 199

Hardened Managed PoE Ethernet Switch
User’s Manual 153
VLAN
VLAN Mode Setting, 802.1Q VLAN Setting, 802.1Q Port Setting, Port Based
VLAN
802.1Q VLAN Setting
VLAN Database:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use vlan database command to enter the VLAN configuration mode.
3.
Command Syntax:
vlan database
4.
Example:
The following example changes to VLAN configuration mode from Configure
mode:
switch_a(config)#vlan database
switch_a(config-vlan)#
Add VLAN/Delete VLAN:
1.
Command Mode: VLAN Configure mode
Logon to Configure Mode (Configure Terminal Mode).
Logon to VLAN Configure Mode.
The
switch_a(config-vlan)# prompt will show on the screen.
switch_a(config)#vlan database
switch_a(config-vlan)#
2.
Usage:
This command enables or disables the state of a particular VLAN on a bridge
basis. Specifying the disable state causes all forwarding over the specified
VLAN ID on the specified bridge to cease. Specifying the enable state allows
forwarding of frames on the specified VLAN-aware bridge.
3.
Command Syntax:
vlan VLANID bridge GROUP name VLAN_NAME state enable/disable
no vlan VLANID bridge GROUP
VLANID The VID of the VLAN that will be enabled or disabled on the bridge
<2-4094>.