SignaMax 065-7700, User Manual

Page: 172 / 199

Hardened Managed PoE Ethernet Switch
User’s Manual 171
802.1x
Radius Configuration, Port Authentication
Radius Configuration
Radius Status:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use dot1x system-auth-ctrl command to globally enable authentication.
Use no dot1x system-auth-ctrl command to globally disable authentication.
3.
Command Syntax:
(no) dot1x system-auth-ctrl
4.
Example:
The following example globally enables authentication:
switch_a(config)#dot1x system-auth-ctrl
switch_a(config)#
Radius Server IP:
Radius Server Port:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to specify the IP address of the remote radius server host
and assign authentication and accounting destination port number.
3.
Command Syntax:
(no) radius-server host IP-ADDRESS auth-port PORT
IP-ADDRESS A.B.C.D specifies the IP address of the radius server host.
PORT specifies the UDP destination port for authentication requests. The
host is not used for authentication if set to 0.
4.
Example:
The following example specifies the IP address ( 192.168.1.100 ) of the
remote radius server host and assigns authentication and accounting