Sierra InnovaMass 240i Series, Instruction Manual, Page: 35 / 115

35
Summary of Menus/Tables
1. Main Menu: Displays Measured Variables and Initial Setup (page 34)
2. Sub Menus: Set-up, Calibration, and Diagnostics menus (page 36)
3. Calibration: Set-up Dial-A-Fluid and Dial-A-Pipe (page 36)
4. Diagnostics: Meter status and Troubleshooting (page 45)
5. Meter Status: Gives Error Codes (page 46)
6. Low/High: Shows low/high process values (page 53)
7. Sensor Tune: Tune to a specific application (page 55)
8. Fluid Properties: Simulate Temp, Pressure, Density and Viscosity (page 61)
9. Process T and P: Adjust T&P Units and simulate T, P (page 63)
10. Totalizer: Set-up Totalizer (page 66)
11. Alarms: Select Alarm Types (page 70)
12. Flow Alarms: Set Low and High Alarms (page 71)
13. Outputs: Set-up and Test All Analog Outputs (page 74)
14. Reference Conditions: Set Normal or Standard (page 78)
Start-up Routine
When the meter is first powered up, it will cycle through set-up data. See an example below of
the type of screens you will see. A “!” then * will flash as the meter boots up, then disappear.
1.
Product name and firmware version. Left is main PCA / right is display PCA
2. Serial Number
3.
Full Scale
4.
Fluid
5. Pipe ID
If “!” remains, the meter has encountered a fault. Refer to the “Diagnostic
sub-menu” then “Meter Status” for details.
240i/241i
V1.0.X/V1.0.X
Serial
1234XXXX
Full Scale
100.00 SCFM
Dial-A-Fluid
Carbon Dioxide
Dial-A-Pipe ID
1234XXXX/ In