Siemens SITRANS FUP1010, Operating Instructions Manual, Page: 81 / 208

Display Logger
This menu cell allows you to send the Logger contents to the display screen. This command
is effective only after a successful install. You can set the report to scroll on the screen with
or without line-wrap. Selecting line wrap, forces a line feed after approximately 40 characters.
In addition, you have to enable datalogging and then select items in the Logger Setup menu.
Note that this command transmits the data from both channels/paths.
To send Logger contents to the display screen:
1. Press <Right Arrow> to access the [Display Logger] option list.
2. Scroll cursor to either [Line Wrap] or [No Line Wrap] by pressing <Up/Down Arrow>.
3. To view Logger contents press <ENT>.
4. To return to [Logger Control] press <MENU>.
Output Logger
This menu cell allows you to send the Logger contents to an external device (usually a
computer or printer) via the flowmeter’s RS-232 Serial I/O port. This command is effective only
after a successful install. In addition, you have to enable datalogging and select data items in
the [Logger Setup] menu.
The flowmeter interfaces with most serial printers or personal computers for Logger printouts.
You must use the proper cabling between the flowmeter and the external device. In addition,
you must configure the RS-232 Setup correctly. You should turn off the Logger function before
you transmit an extensive printout. This will avoid contaminating the printout with new Logger
data. Logger reports are sequential ASCII text files.
To send Logger contents to the RS-232 Serial Port:
1. Check the flowmeter-to-external device connections and your RS-232 Setup parameters
(see RS-232 Setup menu).
2. To access the [Output Logger] option list press <Right Arrow>.
3. Scroll the cursor to [Yes] by pressing <Up/Down Arrow>.
Functions
7.3 Logger Control
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01 79