Operation
5.10 Parameters
FIDAMAT 6-G
Operating instructions, 07/2006, A5E00478463
5-29
5.10.4
On/off functions (function 52)
Figure 5-31 On/off functions
Note
Device-specific on/off functions can only be called via the first component ("THC").
With this function, you can easily switch other functions on/off, such as the ones listed in the
above function screen.
Thanks to this simplified operation, these functions do not have the longer paths through
various menus. For better orientation, function numbers were also specified.
Activated functions are marked by "■", deactivated ones by "□". Using the fifth softkey
("...continue"), jump into the next function screen with further functions.
Function 52 is used to switch the following functions on and off:
Table 5-4
Functions switched on/off by function 52
Description
Fct. no.
Remarks
Total calibration
23
Automatic measuring range switch
40
Limit monitoring 1
51
Limit monitoring 2
51
Limit monitoring 3
51
Limit monitoring 4
51
Suppress negative measured values for display
55
Block logbook
60
Suppress negative measured values
70
Fault/Maint. A/ CTRL/ NAMUR
72
Measured value memory
77
Flag if tolerance is exceeded
78
Temperature recompensation of zero point
86