Siemens APACS+, Installation And Service Instruction

Page: 31 / 65

SD39EAM-1r4 Installation
September 2005 2-15
3. Install J1 at its assigned location as follows:
1) Angle the top edge of J1 toward the backplane’s extruded spacer and insert it in the spacer’s
groove.
2) Slide J1 in the groove until it is aligned vertically and horizontally with the correct slot # and pin.
3) Carefully lower J1 and engage the alignment pin with its pin mounting hole. Firmly push down
to seat J1 on the pin. When J1 is properly seated, the pin will be flush with or project slightly
above J1's face.
4) Tighten J1's captive mounting screw, which is automatically aligned with its panel mounting
hole.
5) Get two labels from the bag of EAM labels. Record on each label the appropriate numbers noted
in the above step 2 (see Figure 1-1). Attach one label to J1 as shown in Figure 1-1.
6) At the P2 end of the cable, attach a second label; see Figure 1-1.
4. Key cable connector P2.
1) Get the PN 16056-435 Cable Keying Kit set aside in step 3 of section 2.6.1.
2) Refer to Figure 2-7 for the assigned keying pattern and install the pins in accordance with the
supplied Instruction.
5. Connect the free end of the I/O Cable to an I/O termination assembly. Perform either of the following
steps 1) or 2) depending upon I/O Cable type.