Pipe diameter (menu 7.1.3.1)
This value represents the average inside diameter of the actual pipe and should only be changed
for SONOKIT.
Note
Large sizes
With nominal diameter settings above DN 2000 the deivce may not work properly.
Roughness (menu 7.1.3.2)
Roughness is the value for the inner pipe surface and should only be changed for SONOKIT.
The range of this value is 0.01 mm to 10.0 mm. The standard Siemens sensors have a roughness
of approximately 0.4 mm.
Pipe material
Typical roughness
Smooth plastic pipe
0.1 mm
Polished stainless steel pipe
0.1 mm
Standard carbon steel pipe
0.4 mm
Rusty carbon steel pipe
1 to 2 mm
Concrete pipe
2 to 5 mm
Tracks (menu 7.1.4)
This menu consists of the parameters for the path settings and should only be changed for
SONOKIT. In the following table only the parameters for path 1 are explained. The parameters
for paths 2, 3 and 4 are to be handled equally.
Functions
7.7 Sensor parameters (menu 7)
SITRANS FUS060 with PROFIBUS PA
Operating Instructions, 09/2021, A5E02225054-AD
69