Siemens 7ME305, Operating Instructions Manual, Page: 117 / 124

Menu
code Device function,
Parameters Description Factory setting Setting options Read
or write
7.1.3.2.
1 Engr.unit Unit selection (mm or in) mm mm
in Write
7.1.3.2.
2 Roughness Roughness of the inner pipe wall
(mm or in); for example 0.04 m for
steel pipes 0.4 mm (0.015748
in) 0.01 to 10.0 mm Write
7.1.4 Tracks
7.1.4.1 Track 1
7.1.4.1.
1 Length 1 Length of path 1 (m). The distance
between the two ultrasonic transduc‐
ers of path 1, see Figure 7-6 Sensor
geometry data (Page 70). Depending of sensor
size selected at order‐
ing >0 to 8.0 m Write
7.1.4.1.
2 Angle 1 Angle of path 1 Depending of sensor
size selected at order‐
ing 0 to 89° Write
7.1.4.1.
3 Displacement 1 Displacement of path 1 (m)
Note: The value must be smaller than
the half entered pipe diameter (see
menu 7.1.3.2.2).
For 1-path the value must be set to 0 Depending of sensor
size selected at order‐
ing 0 to 1.5 m Write
7.1.4.1.
4 Trig. con 1 Up The signal trigger constant of the first
path up. SONO 3100 and SO‐
NOKIT:
-0.75
SONO 3100 (special
applications):
Depending on the or‐
dered system
SONO 3300:
Depending on the or‐
dered sensor -1.40 to +1.40 Write
7.1.4.1.
5 Trig. con 1 Dw The signal trigger constant of the first
path down. SONO 3100 and SO‐
NOKIT:
-0.75
SONO 3100 (special
applications):
Depending on the or‐
dered system
SONO 3300:
Depending on the or‐
dered sensor -1.40 to +1.40 Write
7.1.4.1.
6 AUTO cal. 1 The AUTO calibration factor is auto‐
matically calculated
Note: Only shown if AUTO is selected
in menu 7.1.1 Read
7.1.4.1.
6 WET cal. 1 The WET calibration factor of the
path.
Note: Only shown if WET is selected
in menu 7.1.1 Depending on facto‐
ry calibration of the
transmitter, which is
typically done to‐
gether with the or‐
dered sensor 0.0000010 to
100.0000000
(value with 7 frac‐
tional digits) Write
HMI menu structure
D.1 Menu items (FW Rev. 4.00.00)
SITRANS FUS060 with PROFIBUS PA
Operating Instructions, 09/2021, A5E02225054-AD
117