Page 85 of 106
TMS 5001
9.
MAINTENANCE
9.1
CHECKING THE MACHINE
IN CASE OF MAINTENANCE OPERATION:
IT IS NECESSARY TO TURN OFF ONE OF THE TWO SECURITY KEYS (A OR B) TO SWITCH OFF THE MACHINE AND GET INTO IT SAFELY.
IT IS A MANDATORY REQUIREMENT THAT THE OPERATOR TAKES WITH HIM ONE KEY (A OR B) TO GUARANTEE THAT THE MACHINE
DOESN’T WORK. IN THIS ACTION YOU CAN ENSURE THAT ANY OTHER OPERATOR CAN’T TURN ON THE MACHINE WHILE ANOTHER
OPERATOR IS INSIDE IT. (See the chapter 3.4.4.6)
List of elements to be checked and/or replaced (TMS-
5001e)
The table shows the list of tasks, the time required, as well as the material that is
needed in order to make replacements on some occasions.
Frequency (Hours worked or time passed,
whichever finishes first)
Estimated
time
(hours)
Client
Side (Recommended)
Weekly
(80
hours)
Monthly
(400
hours)
6months
(1,200
hours)
12 months
(4,400
hours)
24 months
(8,800
hours)
Control the lack of preforms and/or foreign bodies throughout the starter motor and
after every subsequent stoppage as a result of a defect.
O
O
O
O
O
0.5
Visual control of the following parts of the machine in order to detect possible broken
parts (ascending conveyor belt, preforms, transport, rails, loading and unloading
system, oven, etc.) and clean them of grease, dust, preforms and bottles.
O
O
O
O
O
1
Clean the excess grease in the press and the stretching units.
O
O
O
O
O
0.5
Grease and control central cones of the mould. Check for excessive wear and tear.
O
O
O
O
O
0.5
Cleaning the flat edge of the mould gaskets (area of air outlet).
O
O
O
O
O
1
Check the control of the water and compressed air leaks in the machine.
O
O
O
O
O
0.25
Clean the photocells, the mirrors and the infrared chambers (temperature probes) of
the preforms. With a smooth damp cloth. Do not use abrasive products.
O
O
O
O
O
0.5
Revision of the condition and turning on of the oven lights.
O
O
O
O
O
0.5
Revision of the safety systems, doors and emergency stops.
O
O
O
O
O
0.5
Verification of the tension, alignment and cleaning of the elevator belt
O
O
O
O
O
Summary of Contents for TMS 5001
