Side TMS 5001, Instruction Manual

Page: 7 / 107

Page 6 of 106
TMS 5001
Users should comply with the European standards and directives in force concerning the treatment and
disposal of the pneumatic oil and lubricants used on the machine.
MACHINE NOISE LEVEL
The noise emitted for the machine is 85dB.
For this, all the operator into the machine area must use obligatory audition protection.
GARMENT STANDARDS
The staff operating the machine or carrying out maintenance works on it should observe the essential national
safety requirements in force concerning clothing.
In general terms, safety slip resistant shoes and wearing moccasins, clogs, slippers and any other shoes
hindering the mobility of operators is banned.
Clothing should match each task: overalls or aprons must be made in natural fibre materials (such as cotton)
with a low ignition temperature and they should not be stained with lubricant.
When working in heat-radiating areas the protection gloves should be used. Splash proof goggles must be
worn in those areas in which molten material splash risks or chipping hazards may occur.
Note: while at work, operators should not wear bracelets, watches, rings or chains that might hinder their
mobility or get hooked in the machine components. When working near movable parts, operators must make
sure neither their clothes nor their hair is caught by them.
WARRANTY
The warranty terms and conditions and its duration have been set out in the purchase agreement subscribed
by the purchaser and SIDE, SA
COVERAGE
It will cover all the broken parts or those presenting an excessive wear due to the amount of operating hours.
Once a component under the warranty period has been replaced, it will have to be sent to SIDE, SA should
the latter ask the machine owner to do so for verification purposes.
The warranty concerning any peripheral equipment supplied through SIDE, SA and purchased from other
manufacturers will be that provided by the latter, but it will not exceed the terms and conditions of the warranty
set out and agreed on by the Seller and the Purchaser.
WARANTY EXCLUSION PROVISION
Machine failure due to natural wear (washers, detent bridles, belts...), wrongful manipulation, wrongful use,
collision, meteorological reasons, voltage changes or lack of maintenance according to the stipulations in this
manual will not be covered by the manufacturer during the warranty period.
In order to benefit from the warranty, it is a must to comply with the maintenance stipulations in the Mould
blowing machine manual.
The grease for the lubrication circuit must be KLUBER UH 1 14-1600 GREASE, in order to guarantee the good
operation of the system.