Chapter
10
Operating Instructions
Radio Frequency Identification RFH620 Interrogator
24
8013171/ZO93/2017-08-08
©
SICK AG
•
Germany
•
All rights reserved
Appendi
x
4
Installation
4.1 Overview of installation sequences
This chapter describes the installation sequences for the RFH620 and its external
components.
The typical installation sequences are displayed below:
¾
Selecting the installation location for the RFID device
¾
Aligning the RFH620 to the object carrying the transponder
¾
Installing the power supply
Do not open the bar code scanner's housing. If the device is opened, the SICK AG
warranty shall not apply.
4.2 Installation preparations
The following general requirements should be observed for installation:
¾
Typical space requirement: application-specific and type-dependent (reading range)
¾
Stable installation bracket with sufficient load capacity and measurements suited to
the RFH620 (see chapter RFH620 dimensional drawings)
¾
Shock absorbent and vibration free attachment
The following tools and resources are required for installation:
¾
Two M6 bolts: The bolt length depends on the wall thickness of the base
¾
Tool
4.2.1 Components to be installed
The following components have to be placed ready for installation:
¾
RFH620
¾
Power supply
