Chapter
1
Operating Instructions
Radio Frequency Identification RFI341 Interrogator
8
8013171/ZO93/2017-08-08
© SICK AG • Germany • All rights reserved • Subject to change without notice
Notes On This Document
1
Notes about this Document
1.1
Purpose
This document provides instructions for technical staff on the installation and operation
of the RFID special device RFH620 with two integrated LED’s in the front side:
This document contains information about:
•
Mounting and electrical installation
•
Start-up
•
Use and configuration
•
Replacing
A step-by-step approach is taken for all tasks.
1.2
Target Groups
The target groups for this user guide are:
•
Operating electricians
•
Technicians and engineers
1.3
Deep of information
This document contains all the required information for installation, electrical
installation and operation of the RFID device at the installation location. The factory
default setting (basic configuration) of the RFID device is prepared for the use as a
stand-alone device. Configuration of the RFID device for the application-specific
reading conditions and operation is carried out using the SOPAS-ET configuration
software on a Windows
TM
PC, or – if available – via an external middleware. The
SOPAS-ET configuration software contains an online help system to facilitate
configuration.
1.4
Symbols Used
To gain easier access, some information in this documentation is emphasised as follows:
NOTICE!
Warnings are provided to prevent injury to operating personnel or serious damage to the
RFID Interrogator.
¾
Always read warnings carefully and observe them at all times.
ATTENTION
