![background image](http://html.mh-extra.com/html/sick/mcs200hw-mp/mcs200hw-mp_operating-instructions-manual_1264205063.webp)
Table 30: Series terminals - UPS connection terminals on installation plate
Wire
Cross section in
mm
2
Cross section in
AWG
Tightening torque Nm
Rigid
0.14 ... 4.0
26 ... 12
-
Flexible with ferrules
0.14 ... 2.5
26 ... 14
Flexible with ferrules with insu‐
lating collar
0.14 ... 2.5
26 ... 14
13.2.10
Heated sample gas line (option)
Table 31: Sample gas line - characteristics
Sample gas line
Length
Max. 50 m certified, longer sample gas lines on request
Ambient temperature
–20 ... 80 °C
Working temperature
Max. 200 °C
Temperature control
1 x Pt100
1
Voltage supply
115 V or 230 V
Power input
90 VA/m
Degree of protection
IP 43
1
With heating length >35 m, the sample gas line has two independent heating circuits. The second
heating circuit can be connected to this optional temperature control circuit.
13.2.11
Switching on the circuit breakers again
Overview
The circuit breakers are located at the bottom of the electronics unit.
The circuit breakers are labeled.
TUBE 1
ELECTRONIC
FILTER / PROBE 1
FILTER / PROBE 2
TUBE 3
CELL
TUBE 2
DEVICE
Procedure
When a circuit breaker has triggered
1.
Press the circuit breaker pin back in again.
2.
If this does not switch the circuit breaker on again, wait a few minutes (cooling
down phase) and press the pin back in again.
3.
If this does not switch the circuit breaker on again, check the assembly and
replace when necessary.
13.2.12
Torques for screw fittings
Overview
Tighten all screw connections, for which no tightening torque or no pretension force is
specified in drawings or Assembly Instructions, according to VDI 2230.
TECHNICAL DATA
13
8026608/AE00/V1-0/2021-10 | SICK
O P E R A T I N G I N S T R U C T I O N S | MCS200HW-MP
63
Subject to change without notice