![background image](http://html.mh-extra.com/html/sick/mcs200hw-mp/mcs200hw-mp_operating-instructions-manual_1264205022.webp)
≥ 100 mm
2
5
0
mm
R
≥
3
0
0
mm
Figure 4: Lines – clearance and bending radius
4.
Roll up excess length at the gas sampling unit. Leave enough length for pulling the
gas sampling unit.
5.
Fasten the sample gas line accordingly (e.g. on cable trays).
5.4.2.2
Connecting the heated sample gas line to the analyzer
Procedure
1.
Unscrew cell cover and remove.
2.
Remove protective cap from sample gas line and cell connection.
3.
Insert sample gas line to stop in the clamping ring screw connection on the cell.
4.
If necessary, provide an additional clamping ring screw connection at the installa‐
tion site for sufficient strain relief.
5.
Attach red foam insulation to the clamping ring screw connection. Bind together
with a cable clip. No thermal bridges may remain.
6.
Close cell again.
7.
Screw cable gland tight.
8.
Push electric lines downwards through the cable duct.
9.
Connect power supply of the sample gas line.
5.4.3
Using a push-in fitting (pneumatic)
Overview
Figure 5: Push-in fitting with retaining ring (example shown)
1
Retaining ring
2
Tube
5
MOUNTING
22
O P E R A T I N G I N S T R U C T I O N S | MCS200HW-MP
8026608/AE00/V1-0/2021-10 | SICK
Subject to change without notice