![background image](http://html.mh-extra.com/html/sick/mcs200hw-mp/mcs200hw-mp_operating-instructions-manual_1264205023.webp)
Procedure
Fitting the tube
1.
Push the tube in.
Removing the tube
1.
Press the retaining ring in.
2.
Pull the tube out.
5.4.4
Laying the hose bundle line
Important information
NOTICE
Protect the line from damage (chafing through vibration, mechanical load).
Procedure
1.
Lay the hose bundle line from the gas sampling unit to the measuring device.
°
An additional length of 0.5 m is required at the gas sampling unit for the
internal lines.
°
An additional length of 3.5 m is required from the installation plate for the
internal lines.
2.
Observe a minimum bending radius of 300 mm.
≥ 100 mm
R
≥
3
0
0
m
m
Figure 6: Lines – clearance and bending radius
3.
Fasten the hose bundle line accordingly (e.g. on cable trays).
5.4.5
Connecting the signal lines on the analyzer
Connect the signal lines according to the wiring diagram.
5.4.6
Setting the pressure reducer module
Overview
The external air supply is fitted on the pressure reducer module.
The instrument air is used as both induction air for the ejector (cell) and zero/control
air.
There are two possibilities of connecting instrument air:
•
One (1) shared instrument air supply for ejector air and zero/control air (inlet 1)
•
Separate instrument air supply for:
°
Ejector air (inlet 2)
°
and zero/control air (inlet 1)
MOUNTING
5
8026608/AE00/V1-0/2021-10 | SICK
O P E R A T I N G I N S T R U C T I O N S | MCS200HW-MP
23
Subject to change without notice