![background image](http://html.mh-extra.com/html/sick/mcs200hw-mp/mcs200hw-mp_operating-instructions-manual_1264205048.webp)
Messages not included in the following Table have no further significance for operation.
Important information
Messages with status “F” must be cleared first.
Close the logbook and open it again to check whether the error is cleared.
Trigger: System
C = Classification
F = Failure
M = Maintenance request
Table 6: Error codes - System
Code
Error text
K Description
Possible clearance
S001
Temperature too
high
F Measuring cell temperature too
high
When T
≥
360.7 °C: Check plug-in
connectors.
When ok: Call SICK Service.
When T < 360.7 °C: Call SICK Serv‐
ice.
Optic head temperature too high
When T
≥
151.2 °C: Check plug-in
connectors.
When ok: Call SICK Service.
When T < 151.2 °C:
When temperature
≥
55 °C: Replace
filter pad.
Otherwise, call SICK Service.
Temperature of heating for an
assembly too high
Check device documentation to clar‐
ify which assembly is affected.
When T
≥
360.7 °C: Check plug-in
connectors.
When ok: Call SICK Service.
When T < 360.7 °C: Call SICK Serv‐
ice.
LPMS01 (1/2 control) tempera‐
ture too high
When temperature < 55 °C: Check
fan of electronics unit / clean or
replace filter pad.
Otherwise, call SICK Service.
LPMS02 (power electronics) tem‐
perature too high
When temperature <55 °C: Check
fan of electronics unit / clean or
replace filter pad.
Otherwise, call SICK Service.
When temperature < 55 °C: Call
SICK Service.
LPMS03 temperature too high
When no error message for optic
head temperature: Call SICK Service.
Otherwise, see optic head error clear‐
ance
11
TROUBLESHOOTING
48
O P E R A T I N G I N S T R U C T I O N S | MCS200HW-MP
8026608/AE00/V1-0/2021-10 | SICK
Subject to change without notice