SICK LMS5 Series, Operating Instructions Manual

Page: 57 / 94

LMS500 Pro Indoor: “Power/Data/I/O” connection in system plug
Table 20: LMS500 Pro Indoor: Terminal assignment of the “Power/Data/I/O” connection
Male/female connector Contact Short form Signal description
01 02 03 04 05 06 07 08 09 10 11 12 13
14 15 16 17 18 19 20 21 22 23 24 25 26
Figure 40: 2 x terminal strip,
13-pin
01 V
S
Sensor supply voltage
02 GND Ground sensor
03 OUT1 Digital output 1
04 OUT2 Digital output 2
05 OUT3 Digital output 3
06 IN1 Digital input 1
07 IN2 Digital input 2
08 GND IN1/2 Ground for digital inputs 1 and 2
09 GND IN3/4/IN Sync Ground for digital inputs 3 and 4 / Input
Synchronization
10 IN3 Digital input 3
11 IN4/IN Sync Digital input 4 / Synchronization input
12 OUT4 Digital output 4
13 OUT5 Digital output 5
14 V
S
OUT Digital output supply voltage
15 GND V
S
OUT Supply voltage ground of digital outputs
16 TD+ RS-422 sender
17 TD–/TxD RS-422 / RS-232 sender
18 GND RS RS-422/RS-232 ground
19 RD–/RxD RS-422/RS-232 receiver
20 RD+ RS-422 receiver
21 RS shield RS-422/RS-232 shielding
22 CAN shield CAN bus shielding
23 CAN H CAN bus HIGH
24 GND CAN Ground CAN-BUS
25 CAN L CAN bus LOW
26 OUT6/OUT Sync Digital output 6 / Synchronization output
Yellow bypass switch at the system connection
By moving the bypass switch, you can select which pins provide the supply voltage for
the outputs or which pin provides the ground potential of the inputs.
NOTE
If the bypass switch is set as "bridge", a higher power is consumed via the supply cable
of the sensor (supply power for sensor and outputs).
ELECTRICAL INSTALLATION
6
8013796/1ALS/2021-03 | SICK O P E R A T I N G I N S T R U C T I O N S | LMS5xx 57
Subject to change without notice