9.4.5
Changing the limit value
Submenu item "Limit Value" serves to change the limit value currently set.
NOTE
Factory setting: 1000 ppm.
Attention: The value must be within the selected measuring range.
Contact SICK Service when you are not sure which value should be set for your measur‐
ing range.
1
Follow the menu path as described,
2
Enter the password,
see "Entering the password", page 52
3
Enter the changes.
4
Confirm value with "Enter".
5
Press the "Left arrow" to return to menu item "Parameter Settings".
Parameters
back
1000 ppm
Limit Value
edit: Enter
back
select
Parameters
back
Limit: 01000 ppm
select
Parameters
back
select
back
edit:Enter
Limit Value
Limit Value
Limit Value
Limit:
Limit:
Limit
Limit: 1100 ppm
01000 ppm
01000 ppm
Parameters
back
select
Limit Value
Limit: 01100 ppm
Limit Value
Figure 36: Setting the limit value (example)
9.4.6
Changing the active measuring path
Submenu item "Meas.Distance" serves to enter or change the value for the active
measuring path.
WARNING
Adjusting the value for the active measuring path can lead to incorrect measuring
results
The value set at the factory corresponds to the measuring path of the delivered measur‐
ing probe.
b
Contact SICK Service when you want to change the values.
9.4.7
Parameter settings for the external temperature sensor PT1000
Submenu item "Temperature Input" serves to check and change the following settings.
■
Substitute: Default temperature value when the temperature sensor fails
■
External: Using an external temperature sensor
■
Scale Low: Lower limit value for the sample gas temperature
■
Scale High: Upper limit value for the sample gas temperature
■
Input Low: mA signal for the lower limit value of the sample gas temperature
■
Input High: mA signal for the upper limit value of the sample gas temperature
MENUS
9
8008932/16YT/V4-0/2022-02 | SICK
O P E R A T I N G I N S T R U C T I O N S | GM901-02
59
Subject to change without notice
