NOTICE
Avoid damage to the device
For the measuring probes:
■
Measuring probe
GMP
: Ensure uninterrupted purge air feed to the measuring
probe!
■
Measuring probe
GPP
: Ensure uninterrupted power supply to the measuring probe
to heat the optical surfaces!
Procedure
1.
If present, remove the cover of the duct-side flange with tube.
2.
Insert the measuring probe with fitted sender-receiver unit in the duct-side flange
with tube.
NOTICE
A seal must be present between the device flange and the duct
flange.
3.
Fit the measuring probe on the duct-side flange. Use the supplied mounting kit.
7.13
Installing the weatherproof cover
The weatherproof cover is installed in two steps:
1
Fit the installation plate on the flange of the purge air fixture and the measuring
probe flange.
2
Place the weatherproof cover on the installation plate.
1
Fit the installation plate on the flange of the purge air fixture:
b
Lay the weatherproof cover upside down on the floor.
b
Open and unhinge the locks on both sides.
b
Pull the installation plate upwards and remove it from the cover.
COMMISSIONING
7
8008932/16YT/V4-0/2022-02 | SICK
O P E R A T I N G I N S T R U C T I O N S | GM901-02
47
Subject to change without notice
